Deck Repair, Staining & Sealing in Ocala
Florida is hard on decks. Sun, rain, and humidity break down wood fast, and a deck that looked great five years ago can turn into a splintered, faded, spongy safety hazard. The good news: you often don't need a full tear-out.
If your framing is structurally sound, we can resurface the deck with fresh boards and new railings — or simply clean, stain, and seal it — at a fraction of full-replacement cost. We start every job with an honest inspection of the joists, ledger board, and footings, and we tell you straight what's worth saving.
Common Repairs We Handle
- Board replacement — rotted, cracked, or warped decking
- Resurfacing — new boards over sound framing
- Staining & sealing to protect wood from sun and rain
- Railing repair & replacement for safety and code
- Structural fixes — joists, ledger boards, and footings
Repair or Replace?
- Sound framing usually means resurfacing is the smart, cheaper call
- Failing structure is safer and often cheaper to rebuild
- Honest inspection first — we never upsell a full rebuild
- Composite upgrade available when you resurface
If your deck is past saving, we'll talk through a custom rebuild or a low-maintenance composite deck. We repair, stain, and seal decks across Dunnellon, Ocklawaha, and Marion County.
Frequently Asked Questions
It comes down to the framing. If the joists, posts, and ledger board are solid, resurfacing makes sense. If we find soft, rotted, or termite-damaged structural wood, replacement is the safer and often cheaper long-term call.
Soft or spongy spots underfoot, boards that flex more than they should, visible mold or dark staining on the underside, and a musty smell near the ledger board are all red flags worth a closer look.
Yes, that is resurfacing, and it is our most common repair project. As long as the substructure passes inspection, new decking and railings go right on top for a fraction of a full rebuild's cost.
Usually, yes. A separating ledger board is a serious safety issue but is often repairable by re-flashing and properly re-fastening the connection, sometimes with added structural hardware.
Resurfacing typically runs a fraction of full replacement cost since the expensive structural work, the framing, footings, and posts, is already done and just needs new decking on top.
Often, yes, once we confirm the existing joist spacing meets composite manufacturer requirements, which sometimes means adding a few extra joists first.
Yes, pressure washing, sanding, staining, and sealing are available as a standalone maintenance visit for decks that just need a refresh, not structural work.
Simple resurfacing jobs often wrap in just a few days, while repairs involving structural framing or a full ledger board replacement can take a week or more.
Fastener corrosion, wood shrinkage around posts, and repeated seasonal expansion and contraction all loosen railing connections over the years, and we rebuild the post-to-frame connection rather than just tightening the same worn screws.
Yes, our general liability and workers compensation coverage applies regardless of who built the original structure, and we always inspect before quoting so there are no surprises once work begins.
Absolutely, a lot of our repair calls start as a routine inspection. We check the ledger board, posts, footings, and joists and give you an honest assessment either way.
Often, yes, depending on how much of the frame survived. We assess wind and water damage separately from cosmetic damage and repair only what actually needs it.